PDA

View Full Version : [help] Helmet view FOV max locked at 85. Why?



tonaz
08-05-2015, 02:03
Hello ppl,
Is there a way to unlock the FOV of helmet cam in order to go higher than 85?
and, is there a way to unlock the seat position limits, i.e. to move it more further? (WASD)

Aldo Zampatti
08-05-2015, 02:20
Try pressing Control+K once and then WASD again. That's another setting. Beware that some FOV key assignations change after pressing Control+k.

Basically there are 3 slots. Normal, Control K (1st) Control K (2nd) and back to normal.

tonaz
08-05-2015, 08:30
Try pressing Control+K once and then WASD again. That's another setting. Beware that some FOV key assignations change after pressing Control+k.

Basically there are 3 slots. Normal, Control K (1st) Control K (2nd) and back to normal.

Do this allow to move-set fovv freely?

Sounds cool i will try later.

Is there a place i can read all these hotkeys?

Ty so much

Morgan Henstridge
08-05-2015, 08:57
I believe the Seat Movement restrictions are so that the Driver model will physically fit inside the car without clipping back through the seat, or up through the roof, etc.

Aldo Zampatti
08-05-2015, 15:30
Do this allow to move-set fovv freely?

Sounds cool i will try later.

Is there a place i can read all these hotkeys?

Ty so much

We'll compile them and post around here soon! :)

Andjem
08-05-2015, 15:33
the fov and seat positions have upper and lower limits to prevent clipping of the helmet / seat / driver textures

tonaz
08-05-2015, 17:11
the fov and seat positions have upper and lower limits to prevent clipping of the helmet / seat / driver textures


if you pay some attention you can get a good result without clipping.
ok, with CTRL+K you can enter edit camera mode, now i can go higher fov (numpad + and -) but the seat position (WASD) can't go further than i would like.
is there any command line for the dev mode?
the command -gold does not seems to work.

Mahjik
08-05-2015, 17:17
is there any command line for the dev mode?
the command -gold does not seems to work.


Dev move was only for development so it's not available in the retail release.

tonaz
08-05-2015, 17:19
Thanks, is there any trick to unlock the seat position limits in helmet cam?
Thanks so much for your help!

Aldo Zampatti
08-05-2015, 18:02
No tricks that I'm aware of.

Roger Prynne
09-05-2015, 18:58
Seat adjustments are based on real life adjustments.

tonaz
09-05-2015, 19:08
Yep. Thanks.

One more thing, when i edit the cam pos pressing ctrl+K, once i find a good pov how can i save it?
it resets every race. do i have to do it every race?

Roger Prynne
09-05-2015, 22:41
Yep