View Full Version : Fanatec Clubsport Wheel base (CSW) - unable to calibrate

06-06-2015, 22:16
Hi all,
I am getting really frustrated as I cannot enjoy Project Cars due to the calibration not working correctly with my Fanatec CSW v1. Each time I follow the calibration process my wheel goes to a 45 degree (10 o'clock) / non centred position which makes driving impossible.
Please can someone help me?

Morgan Henstridge
06-06-2015, 22:23
Hi Sfalfadude, What driver and Firmware combo are you running on the wheel???

We had this once in development phase, but have not seen this happen again.

Have you tried resetting the settings in the controller screen (at the bottom), and then do not calibrate and just try the game?? I never calibrated my CSW V2, and it is perfect in-game.

17-06-2015, 05:07
Try calibrating the wheels center outside the game first. I have a CSW V2 and when I updated my firmware it reset it to an angle about 45 degrees. I don't know if it would have done the same in game because I re-calibrated the steering wheel before going back into the game.