PDA

View Full Version : Best wheel settings for G27 with the latest Pcars update



Doctor Doom
06-07-2015, 11:33
Can someone tell me what settings I should use in my logitech profiler as well as in Pcars settings for FFB. I am looking for best possible settings.

Roger Prynne
06-07-2015, 11:34
http://forum.projectcarsgame.com/showthread.php?22122-G25-G27-SETUP-GUIDE

http://forum.projectcarsgame.com/showthread.php?22938-Jack-Spade-FFB-Tweaker-Files

http://forum.projectcarsgame.com/showthread.php?30820-SEE-POST-453-Patch-1-4-FFB-reports&p=1025100&viewfull=1#post1025100

http://forum.projectcarsgame.com/showthread.php?33699-Temporary-solution-for-FFB-BUG-Logitech-DFGT-%28possibly-G25-G27-too%29

http://forum.projectcarsgame.com/showthread.php?30820-SEE-POST-453-Patch-1-4-FFB-reports&p=1027350&viewfull=1#post1027350

resmania
06-07-2015, 11:38
Tire Force 40, Deadzone Removal 0.8, Use Jack Spade bump plus FFB tweak.
Set all value to 0% on Logitech profiler except for FFB strength.

Doctor Doom
06-07-2015, 13:21
Should I have my wheel set to 900 degrees of rotation? I got all the other settings from the mod files. The other question for the G27 the Deadzone removal says to set it at 0.18 bit what value do I set the deadzone falloff range at? I have it set at default which I think is 0.01 right now.

resmania
06-07-2015, 13:26
Should I have my wheel set to 900 degrees of rotation? I got all the other settings from the mod files. The other question for the G27 the Deadzone removal says to set it at 0.18 bit what value do I set the deadzone falloff range at? I have it set at default which I think is 0.01 right now.

Yes, 900 degrees.. and 0.18 is too high IMO. set it to 0.08 or similar. If the DDR value is too high, wheel tends to oscillates at center.

*Edit: 0.08 not 0.8 :p

Roger Prynne
06-07-2015, 13:28
Should I have my wheel set to 900 degrees of rotation? I got all the other settings from the mod files. The other question for the G27 the Deadzone removal says to set it at 0.18 bit what value do I set the deadzone falloff range at? I have it set at default which I think is 0.01 right now.

900 = yes absolutely

deadzone falloff range = default


ummm 0.8 is much too high.


Have you used wheel checker to check your DZ
It's under the large pics in the G25/27 thread.

Doctor Doom
06-07-2015, 14:38
Ok, I was going by the mod readme file. Soft clip half set to 0.80 and full set to 1.29

It said for dead zone 0.18 but you guys say .08 and set the falloff at default.

Thanks

Mahjik
06-07-2015, 17:01
Moved to the Tech section...