PDA

View Full Version : Formula A



sgana1978
02-09-2015, 20:39
Hi everyone!
Has someone else, using updated pad, great probs driving Formula A?
Going out from pitlane when I open driving straight, car goes oversteer!
There are some pad config that can help?
Tnx

LMR ShOwTiMe875
03-09-2015, 03:36
Do you use traction control?

AdM1
03-09-2015, 06:38
Here's my settings but I think they are considered to be a bit oversensitive for some people.. Try this thread.. http://forum.projectcarsgame.com/showthread.php?23153-Xbox-One-Controller-Configuration-Guide

This is my set up..
*Input Mode 2*
Steering Deadzone -0
Steering Sensitivity - 20
Throttle Deadzone - 0
Throttle Sensitivity - 0
Brake Deadzone - 0
Brake Sensitivity - 70
Clutch Deadzone - 0
Clutch Sensitivity - 50
Speed Sensitivity - 60
Controller Filtering sensitivity - 30
Advanced - OFF

You could turn controller filtering up and steering sensitivity down if you have any trouble. Turn soft steering dampening on too if it's still too twitchy. Slowly you should be able to make it a bit more sensitive once you learn to get used to it.

Just wondering, do you have any throttle control or just boot it straight out the pits? The Formula A spins out easily at low speed so be easy until the aero starts doing its job imo. Could always add some toe in on the rear.

sgana1978
03-09-2015, 20:28
Tnx I'll try this setup.
I use TCS.
What is "input mode 2", ok I know where is but I haven't try yet.