Baseline Wheel FFB Values - Google Sheet & FCM. Universal

[inthebagbud]

How do you run the test? I have selected Step Log 2 from the combobox but I don't see a button or anything to perform the test. I tried Refresh but that didn't seem to do anything.

Schnizz58 - wondered how long it would take until you appeared on here

make sure wheel is connected to pc and then run the software and select the step and it should auto start

[Schnizz58]

It doesn't do anything.

[inthebagbud]

It doesn't do anything.

daft question is wheel plugged into power socket as well?

[Schnizz58]

Yes, it had to talk to the wheel in order to fill out the status box on the right (and include it in the list of devices at the top).

[Schnizz58]

wondered how long it would take until you appeared on here

You know I can't resist the siren's song.

[inthebagbud]

Yes, it had to talk to the wheel in order to fill out the status box on the right (and include it in the list of devices at the top).

h'mm not sure why it is not working just tried again on mine connected to pc launched software, wheel is selected automatically and pick log 2 from list and after a couple of seconds wheel starts going through test routine

[Schnizz58]

OK well I'mma go watch the USCC from Lime Rock, lol. Peace...

ETA: Well I've never seen that before. There was an incident that took out the leaders in both classes at the same time!

[poirqc]

Well, i kept the Scoops calculation in the sheet. However, i still have too many question about it so take it with a grain of salt.

With that said, you can clearly see the deadzone of various wheels.

[poirqc]

Here's the output for my G27. Unsurprisingly, it's very similar to the G29 (minus wear and tear on my end I guess). I added the .ods in there as well as a zip file.

I screwed up the horizontal scale, but DRR is at 0.16 (16%)

Attachment 213400

Attachment 213401

Normally, if you replaced the data in the 4 sheets, the scale of the graph should stay the same. I wonder why it did that.

Have a look: G27 FFB Output.zip

Edit - first post updated

[Lars Rosenquist]

Normally, if you replaced the data in the 4 sheets, the scale of the graph should stay the same. I wonder why it did that.

Probably a conversion issue because I opened the .xls in OpenOffice (so not the .ods you sent) and then saved it to .ods.